Lenovo J200 Hardware Maintenance Manual page 158

10. Press down on the metal latch 2 and pivot in the drive cage into place. Slide
11. Connect the power and signal cables to the hard disk drive.
12. Go to "Completing the FRU replacement" on page 161.
152
Hardware Maintenance Manual
9. Align the drive cage pivot pin with the slot 1 in the upper drive cage and
slide the hard disk drive into the chassis.
it forward until it snaps into position.
Note: There are two arrows, one on the upper drive cage and one on the hard
disk drive cage, that are aligned when the hard disk drive is in the
proper position.