Replacing An Optical Drive - Lenovo J200 Hardware Maintenance Manual

Replacing an optical drive

This procedure describes how to remove and replace an optical drive.
10. Go to "Completing the FRU replacement" on page 120.
114
Hardware Maintenance Manual
1. Remove the cover. See "Removing the cover" on page 85.
2. Remove the drive bay assembly. See "Accessing system board components
and drives" on page 90.
3. Release the optical drive from the drive bay assembly by pressing inward on
the blue retainer at the side of the drive.
4. Slide the optical drive being replaced out the front of the drive bay assembly.
5. Remove the retainer bracket from the failing drive and install it on the new
drive.
6. Install the new optical drive into the bay until it snaps into position.
7. Reconnect the signal and power cables to the rear of the optical drive.
8. Align the drive bay assembly with the two slots and rails on the sides of the
chassis and slide the drive bay assembly towards the rear of the chassis until
it snaps into position.
9. Reinstall the front bezel.