10. Holding the microprocessor with your fingers, position the microprocessor so
11. Lower the microprocessor straight down into the socket.
12. To secure the microprocessor in the socket, close the microprocessor retainer
13. Install the heat sink and fan assembly on the system board.
14. Connect the heat sink and fan assembly cable to the system board. See the
15. Position the fan duct on the heat sink fan.
106
Hardware Maintenance Manual
that the triangle 1 is aligned with the corresponding triangle on the socket.
Note: Install the black protective cover that was removed from the new
microprocessor onto the defective microprocessor after the installation is
complete.
and lock it into position with the small handle.
system board illustration for your machine type at "Locating parts on the
system board" on page 87.