Removing And Replacing The Front Panel - HP Brio ba300 Troubleshooting Manual

Removing and Replacing the Front Panel

To Remove the Front Panel
1 With the cover removed, press in the two plastic clips on one side of the panel until the panel begins
to come off.
2 Press in the two plastic clips on the other side of the panel until the panel is completely free.
3 Carefully remove the status panel connector connected from the rear of the front panel.
status panel
connector
4 Lay the front panel on a flat surface beside the PC.
To Replace the Front Panel
1 Reconnect the status panel connector to the rear of the panel, taking care to connect it the right way
round.
2 Insert the two plastic clips on one side of the panel then snap the panel into place.
Note If the PC does not start properly or will not start at all, you may have reconnected the status panel connector wrongl y . Remove the
front panel and check the connection of the cable.
If You Have a Problem
31