HP Brio ba300 Troubleshooting Manual page 10

If You Have a Problem
The PC Hangs During Startup
Your memory modules are of the correct type
The expansion card you have installed is
compatible
That you have not made any changes to the PC's
Setup program that may be causing the problem
I I I I f f f f t t t t h h h h e e e e p p p p r r r r ob ob ob obl l l l e e e e m m m m p p p p e e e e r r r r s s s s i i i i s s s s t t t t s s s s , , , , c c c c o o o o n n n n t t t t a a a a c c c c t t t t y y y y o o o o u u u u r r r r a a a a u u u u t t t t h h h h o o o o r r r r i i i i z z z z e e e e d d d d s s s s u u u u pp pp pp ppo o o o rt rt rt rt p p p p r r r r o o o o v v v v i i i i d d d d e e e e r r r r
You Get a "non-system disk" or "operating system not found" Message
You didn't leave a non-bootable floppy disk in
your floppy drive when you started the PC
The device boot order is correct in the Setup
program
10
Have you checked that...
Have you checked that...
Ö
1 Disconnect the PC's power cord.
2 Remove the PC's cover (refer to page 29).
3 Replace the memory module with a known working memory module.
4 Reconnect the PC's power cord and start up the PC.
Ö
1 Disconnect the PC's power cord.
2 Remove the PC's cover (see page 29).
3 Remove the expansion card (see the Brio BA300 Upgrade Guide, details
on page 5).
4 Reconnect the PC's power cord and start up the PC.
Ö
1 Enter the Setup program by pressing F2 when prompted during
startup. Refer to page 25 for more information.
2 Reload the default Setup values by pressing F9.
3 Press F10 to exit the Setup program saving changes.
Ö
1 Check for a non-bootable floppy disk in the floppy drive.
2 Remove the floppy disk if there is one in the drive.
3 Restart the PC.
Ö
1 Enter the Setup program by pressing F2 when prompted during
startup. Refer to page 25 for more information.
2 Reload the default Setup values by pressing F9.
3 Press F10 to exit the Setup program saving changes.
How
How