Accessing Components in the PC
This section provides basic information on accessing internal components in your PC. More detailed
information is available in the Brio BA300 Upgrade Guide, a PDF document that can be downloaded
from the HP Brio support web site (www.hp.com/go/briosupport).
Removing the Cover
WARNING
For your safety, disconnect the power cord and all external cables.
1 Place the PC on a flat surface and stand behind it.
2 Disconnect all cables from the rear of the PC.
3 Loosen the three screws at the rear of the PC with a star (Philips) screwdriver.
4 Slide the cover back by about 1cm (0.3 inches).
5 Pulling the bottom edges of the cover apart slightly, lift it up and off the PC.
If You Have a Problem
29