Linking And Unlinking Trays - Lexmark C746 User Manual

Using C748x
4
Load the paper or specialty media. Slide the stack into the multipurpose feeder until it comes to a stop.
Notes:
•
Make sure paper or specialty media does not exceed the maximum paper fill indicator.
•
Load only one size and type of paper or specialty media at a time.
• Paper or specialty media should lie flat and fit loosely in the multipurpose feeder.
•
If the paper or specialty media is pushed too far into the multipurpose feeder, then press the paper release
lever to remove it.
• Load envelopes with the flap on the right side up and the stamp edge entering the printer first.
Warning—Potential Damage: Never use envelopes with stamps, clasps, snaps, windows, coated linings, or
self‑stick adhesives. These envelopes may severely damage the printer.
5
From the printer control panel, verify the paper size and paper type setting for the feeder based on the paper you
loaded.

Linking and unlinking trays

When the paper size and paper type for any trays are the same, the printer will link those trays. When one linked tray
becomes empty, paper will feed from the next linked tray. It is recommended to give all unique paper, such as letterhead
and different colored plain papers, a different custom type name so that the trays they are in will not automatically
link.
Unlinking trays
1
Open a Web browser, and then type the printer IP address in the address field.
Notes:
•
View the printer IP address on the printer home screen. The IP address appears as four sets of numbers
separated by periods, such as 123.123.123.123.
104