Table of Contents
Advertisement
List of parameters
Items in [Display] are character strings to be displayed on LED. Characters in quotation marks
shows those in the character strings to be displayed on LED.
NO.
Item
0
Seam length
1
Flap sewing
2
Flap correction
- start of sewing
3
Flap correction
- end of sewing
4
Flap clamp
5
Flap clamp operation
6
Sewing speed at lock stitch
sewing
7
Stitch pitch
8
Tack stitch method
- start of sewing and end of
sewing in common
9
Tack stitch length
- start of sewing and end of
sewing in common
10
Sewing speed at tack stitch
- start of sewing and end of
sewing in common
11
Tack stitch pitch - start of
sewing and end of sewing
in common
12
Needle drop number on the
same spot - start of sewing
Display
Gauge
8-14 mm
16-20 mm
* Sewing can be performed for the space no more than 29 mm by
setting the center knife correction value to +.
Not sewing
Left
Right
(front and rear end detection)
-9.9 - 9.9mm (0.1mm pitch)
-9.9 - 9.9mm (0.1mm pitch)
Not used
Left only used
Right only used
Both used
Operation depends on settings for the flap clamp. (0 to 3)
Refer to the table 1.
200,500,800,1000,1200,1500,1800,2000,2200,2500,2800,3000 rpm
1.8 - 3.4mm (0.1mm pitch)
Condense
"C--1"
V Back tack "V--2"
N Back tack "N--3"
0.0 - 6.0mm (1mm pitch)
200, 500, 800, 1000, 1200, 1500, 1800, 2000rpm
The sewing will not exceed the one at lock stitch sewing.
The sewing at back tack is no more than 1500 rpm.
Condense: 0.4 - 2.0mm (0.1mm pitch)
Back tack: 0.8 - 3.4mm (0.1mm pitch)
1 to 5 needles
BAS-6150
Contents (configurable values)
Center knife OFF
Center knife ON
15-220 (250) mm
30-220 (250) mm*
38-220 (250) mm
38-220 (250) mm
Chapter 3 Settings
Initial
values
150
0.0
0.0
0
2500
2.4
4.0
1000
1.0
1
41
Advertisement
Table of Contents
