Table of Contents
Advertisement
NO.
Item
26
Lower thread last stitch
trimming
27
Distance to operate the
lower thread knife
28
Folding plate ON timing
29
Standby timer after the
folding plate ON
30
Folding plate operation at
single welting
31
Setting for the roller cloth
sensor
32
Roller cloth sensor opera-
tion
33
Time to rotate after the
roller down
34
Time to go up after the
roller stops rotating
35
Operation after the thread
breakage
36
Timer for standby time
after the flap clamp ON
37
Flap sensor and needle drop
distance - start of sewing
Display
Not trimmed
Trimmed
Selection is made to decide the lower thread be cut at the
last stitch. When set to OFF, the lower thread is trimmed as
the clamp is moving to the corner knife position.
0 to 70 mm
Distance from the end of sewing to the lower thread knife's
operation when [No. 26 The last stitch trimming] is set to
OFF.
The lower thread is trimmed as the clamp is moving to the
corner knife position.(This setting is performed to adjust the
amount of the remained lower thread.)
0.0 to 9.9 second(s)
Time from T-gauge descent to the folding plate ON when
the cloth setting is performed.
0.0 to 9.9 second(s)
Time for the start of next operation after the folding plate
ON.
Not used
Only left used
Only right used
Both used
Not used
Used
Setting is performed as to stop the operation by the cloth
sensor at the time of roller driving. The direction of rotation
is specified by symbols for the roller driving distance.
The roller stops with OFF → ON (ON edge).
The roller stops with ON → OFF (OFF edge).
These are conditions to top the roller when the roller cloth
sensor is used.
0.1 to 9.9 second(s)
0.1 to 9.9 second(s)
Immediate stop "0"
Stop at the end of sewing position "1"
0.1 to 9.9 second
Standby time for the start of the clamp's movement after the
flap clamp ON.
30.0 to 40.0mm
BAS-6150
Contents (configurable values)
Chapter 7 Environment setting
Initial
value
0
0.1
0.2
—
0.5
0.5
1
0.2
35.0
79
Advertisement
Table of Contents
