Table of Contents
Advertisement
Chapter 7 Environment setting
NO.
Item
38
Flap sensor and needle drop
distance - end of sewing
39
Setting for lower thread
volume detection
40
Stacker operation mode
41
Stacker operation timer 1
42
Stacker operation timer 2
43
Stacker operation timer 3
44
Stacker operation timer 4
45
Stacker operation timer 5
46
Stacker operation timer 6
47
Stacker operation timer 7
48
Stacker operation timer 8
49
T-gauge ascent timing
50
Standby position
51
Feed position
52
Stacking position
53
Test sewing speed
54
Center knife setting during
the machine test
80
Display
30.0 to 40.0mm
Not used,
Used
(remained volume automatic sensing)
0 to 9 (The number varies with the kind of stackers.)
0.0 to 9.9 second(s) (Refer to the Table 3 for initial values.)
0.0 to 9.9 second(s) (Refer to the Table 3 for initial values.)
0.0 to 9.9 second(s) (Refer to the Table 3 for initial values.)
0.0 to 9.9 second(s) (Refer to the Table 3 for initial values.)
0.0 to 9.9 second(s) (Refer to the Table 3 for initial values.)
0.0 to 9.9 second(s) (Refer to the Table 3 for initial values.)
0.0 to 9.9 second(s) (Refer to the Table 3 for initial values.)
0.0 to 9.9 second(s) (Refer to the Table 3 for initial values.)
0 to 100 mm
The distance between the reference mark after clamping and
the needle drop position with T-gauge up.
0 to 465mm
The distance between the reference mark after clamping and
the home position at the standby position.
340 to 465 mm
The distance between the reference mark after clamping and
the needle drop position at the feed position.
340 to 465 mm
The distance between the reference mark after clamping and
the home position at the stacking position.
200, 500, 800, 1000, 1200, 1500, 1800, 2000, 2200, 2500,
2800, 3000 rpm
BAS-6150
Contents (configurable values)
Initial
value
35.0
—
0
30
340
465
425
1000
Advertisement
Table of Contents
