Table of Contents
Advertisement
Chapter 3 Settings
1. Program operation
(Note) • When program lock setting ([2. Program lock] in Chapter 3) is performed, items that can be changed
are restricted.
• 10 kinds of sewing program (1-9, 0) can be set.
Sewing pattern
BAS-6150 : Parallel sewing
BAS-6150 (flap specifications) :
When the standby mode is ON (the power supply ON and the start switch pressed), the following
settings can be performed for items in the menu q on which LED is lit. (for each program No.)
LED lit menu
S.LENGTH
ADJUST
CYCLE
COUNTER
Press the "ENTER" key e after the item is selected with the "SELECT" key w. Setting can be
performed for environment parameters by pressing the "SELECT" key e with the "ENTER" key
w pressed in the standby mode.(Refer to [Chapter 7. Environment Setting])
1-1. Contents of the parameter
Contents of each parameter can be changed.
1. Keep pressing the "SELECT" key w till LED t in [S.LENGTH] is lit.
2. Press ∆∇ key to display the program No. you want to change in the contents display window
r.
3. The mode is changed to the program mode by pressing the "ENTER" key e. The parameter
No. is lit on the program No. display window r. The contents of the parameter is lit to blink
in the contents display window y. (Display and contents are displayed alternately.)
4. Press ∆∇ key to change the parameter No. in the program No. display window r.
5. Press
key to change the contents. Return to step 4 if you need to change other parameters.
6. Press the "ENTER" key e to memorize the changed contents.
40
t
w
q
Parallel sewing, flap sewing (right and left)
Setting item
Parameter
Center knife, corner knife correction value
Cycle program
Lower thread counter, production counter
r
y
e
BAS-6150
1457S
Advertisement
Table of Contents
