Table of Contents
Advertisement
Chapter 3 Settings
3. How to set double and single welting
q
The position is confirmed as described below:
1. Press "FEED" key q to move the carriage feed to the feed position.
2. Loosen the bolt and replace the gauge with the one for the single welting.
Push the single welting gauge up as far as it goes.
3. Loosen the screw on set color r and tighten it again putting the carriage feed e to the collar
B. (The position of the collar A is for double welting.)
4. Press down the foot forward switch with "ENTER" key w pressed and the binder goes
down(goes up).
5. Confirm the cloth slide plate is in parallel with the binder.
6. Press "FEED" key q with the binder up and the carriage feed is returned to the standby
position.
* When the setting for the memory switch 3 (environment parameter No.63) is set to ON, press the "ENTER" key w with the "FEED"
key q being pressed.
52
w
(double)
w
1457S
r
B
e
BAS-6150
A
1591S
Bolt
w
(single)
1484S
Advertisement
Table of Contents
