Format (Formatting Hard Disk); Error Handling (Error Detection Setting); Duplex (Duplex Printing Error Detection Setting) - Kyocera FS-C5150DN Operation Manual

>Hard Disk
>>Format ?
>Error Handling
2
Press or
>

Format (Formatting hard disk)

A new hard disk must be formatted before it can be used in the printer.
Formatting allows data to be written to the hard disk.
This menu is displayed only when the optional hard disk is installed on the
printer.
Note Formatting will destroy any existing data on a storage
device including a used hard disk.
Formatting of the hard disk must be executed from the printer.
Use the procedure below to format the hard disk.
When a new hard disk is inserted in the printer's slot, Format error
Hard disk will appear on the message display.
1
Press while >Hard Disk > is displayed.
2
>>Format appears.
3
Press [OK]. A blinking question mark (?) appears.
4
Press [OK] again.
Processing appears and formatting of the hard disk starts. When
the formatting is successfully completed, the display returns to
Ready.

Error Handling (Error detection setting)

This specifies the settings for the detection methods used for duplex
printing errors and for paper size and paper type errors when the paper
source is fixed.
The options available in Error Handling are as follows:

• Duplex (Duplex printing error detection setting)

• Paper Mismatch (Detection settings for paper size/type errors when
the paper source is fixed)
• MP Tray Empty (Warning when the MP tray is empty)
1
Press while Device Common > is displayed.
2
Press or
>
Duplex (Duplex printing error detection setting)
If the error detection setting for duplex printing has been turned On, and
you attempt to print onto a paper size and paper type that cannot be used
for duplex printing, the Duplex disabled Press GO error message
will be displayed and printing will stop.
On • To print onto one-side of the paper only when this message
is displayed, press [GO].
• Press [Cancel] to cancel the printing itself.
4-57
repeatedly until >Hard Disk > appears.
repeatedly until >Error Handling > appears.
Using the Operation Panel