[Half-Fold Position]; [Punch Horizontal Position Adjustment] - Konica Minolta bizhub C220 User Manual

7.1 [System Settings]

[Half-Fold Position]

Adjust the center staple & fold and half-fold positions for each paper size.
0 Before making any adjustments, create a sample using the half-fold function. Adjust the center staple
position while checking the created sample.
0 This adjustment is available if the Saddle Stitcher SD-509 is installed.
0 When adjusting the half-fold position in parallel with the left edge of paper, contact your service repre-
sentative.
1
Press the Utility/Counter key ö [Administrator Settings] ö [System Settings] ö [Expert Adjustment]
ö [Finisher Adjustment] ö [Half-Fold Position].
2
Select the size of paper of which half-fold position is adjusted.
3
Press [+] or [-] to adjust the half-fold position while checking the sample.
4
Press [OK].
5
Create a sample, and check the print result.

[Punch Horizontal Position Adjustment]

Adjust the horizontal position of the punched holes for each paper type.
0 Before making any adjustments, create a sample using the punch settings. Adjust the center staple po-
sition while checking the created sample.
0 This adjustment is available if the Punch Kit PK-517 is installed.
1
Press Utility/Counterö[Administrator Settings]ö[System Settings]ö[Expert Adjustment]ö[Finisher
Adjustment]ö[Punch Horizontal Position Adjustment].
2
Select the type of paper of which the horizontal punched hole position is adjusted.
3
Press [+] or [-] to adjust the punched hole position while checking the sample.
4
Press [OK].
5
Create a sample, and check the print result.
bizhub C360/C280/C220
7
7-14