Setting Print Quantity; S Etting Print Quantity; To Set Print Quantity; To Change Print Quantity - Kyocera Mita KM-8530 Operation Manual

Setting Print Quantity

This section describes how to set or change print quantity.

To Set Print Quantity

The copier is initially set to copy the original set in amounts determined by the print
quantity setting, then outputs sorted sets.
1.
Enter the desired print quantity from the control panel keypad.
Entered quantity will be displayed on the touch panel.

To Change Print Quantity

Follow the procedure below to change the print quantity that has been already
entered.
1.
Press [C (CLEAR QTY.)].
The quantity displayed on the touch panel will return to 1.
2.
Enter the correct quantity.
Entered quantity will be displayed on the touch panel.
P
Y
COUNTER CLEAR QTY.
P
Y
COUNTER CLEAR QTY.
INT
PRO
S
INT
PRO
S
3
C opying
Operations
Positioning
Originals
Setting Print
Quantity
Set Job During
Warmup
Stop
Scan/Print

Copy Size

Lens Mode
Density
1-1, 2-2
2-1
Multi-Sheet
Bypass Tray
Using
Memory
Output without
Finisher
DF-630/635
Output Modes
Binding
Mode
Recalling
Previous Job
Check Mode
& Proof Copy
Interrupt
Mode
3-7