Punching File Holes In Copies (Punch); P Unching File Holes In Copies (Punch) - Kyocera Mita KM-8530 Operation Manual

Punching File Holes in Copies (Punch)

The Punch mode is available only when the PU-108 Punching unit or PZ-108
Punching/Z-Folding unit option is installed on the DF-630/DF-635 Finisher.
When the Punch mode is selected in combination with any of the Primary (Main) tray
output modes, each copied sheet is punched and output to the Primary tray according
to the selected output mode.
• Some staple positions previously selected may conflict with this
• Special size paper (STD size (special), Non STD size, Wide size)
• The LCT specified as Thick 3 cannot be used.
• If the ATS (Automatic Tray Switching) functions while the machine uses
• Do not punch special paper type such as transparent films, labels, tabbed
• Be sure that the side guide plates of the paper tray are securely aligned
>>>Specifications for Punch Mode<<<
❒
Copy paper size: 11"x17", 8.5"x11" (20 lb paper recommended)
❒
Paper weight: 20 ~ 24 lb
Thin paper: 16 ~ 19 lb
Thick paper: 25 ~ 45* lb
❒
Number of holes: 3 holes
❒
Hole diameter: 0.315" ± 0.020" (8 mm ± 0.5 mm)
❒
Hole pitch: 4.252" ± 0.020" (108 mm ± 0.5 mm)
❒
Incompatible Conditions: Using platen glass (available when using Platen store
mode), Folding, Stapling & Folding, Trimming, Output to Secondary (sub) tray,
Mixed Original (8.5"x11"R, 5.5"x8.5" mixed), Non STD Size, Booklet, Transpar-
ency Interleave
DETAILS
function.
cannot be punched.
the Punch mode, the punch holes may be slightly off the appropriate
positions.
Reminder!
sheets, etc. Otherwise, machine trouble may occur in Punching unit.
to the paper; otherwise the copies may not be punched in position.
* Some 45 lb paper types may not be punched easily.
4.252"
(108 mm)
Weekly
Timer
Rotation
Vertical/Hori-
zontal Zoom
Folding /
Stapling&Folding
Punch
Z-Folding
Trimming
Cover Sheet
Feeding
Using Finisher
Manually
Tandem Mode
7
A dvanced
Information
7-11