Feeding Tape; Feed & Cut; Feed Only - Brother P-Touch PT-2730 User Manual

Feed & Cut
The Feed & Cut function feeds 0.92" (23mm) of blank tape then cuts the tape.
• Be sure to feed tape to remove any slack in the tape and ink ribbon after inserting the tape
cassette.
• Do not pull the label coming out of the tape exit slot. Doing so will cause the ink ribbon
to be discharged with the tape.
• Do not block the tape exit slot during printing or when feeding tape. Doing so will cause the
tape to jam.
1
Hold down the Shift key and press the Preview key.
"Feed & Cut?" will appear on the LCD display.
2
Using the or
Enter.
The message "Feeding Tape... Please Wait" appears while the tape is fed, and
then the tape is cut.
To exit or cancel this function press Escape.

Feed Only

This function will advance the tape approximately 0.92" (23 mm) resulting in a blank
label sticking out of the tape cassette. This action is recommended when using Fabric
and Extra Strength Adhesive tapes, which should be cut using scissors.
1
Hold down the Shift key and press the Preview key.
"Feed & Cut?" will appear on the LCD display.
2
Using the or
Enter key.
The message "Feeding Tape... Please Wait" appears while the tape is fed.
To exit or cancel this function press Escape.

Feeding Tape

key to select the "Feed & Cut" option and then press either OK or
key to select the "Feed Only" option and then press either OK or
1
2
3
4
5
6
7
8
9
Feeding Tape 20