Setting Bar Code Parameters - Brother P-Touch PT-2730 User Manual

Setting Bar Code Parameters

1
Press the Setup key to display the Setup menu, select "Bar Code Setup" using
the or key, and then press the OK or Enter key.
The Bar Code Setup screen is displayed.
Pressing Bar Code key while holding down the Shift key will also allow you to go
to "Bar Code Setup".
2
Select an attribute using the
using the or
Characters may not appear below the bar code even when "On" is selected for "Under #",
depending on the tape width being used, the number of lines entered, or the current
character style settings.
3
Press the OK or Enter key to apply the settings.
• New settings are NOT applied if you do not press the OK or Enter key.
• The "C-Digit" (Check Digit) attribute is only available for the CODE39, I-2/5 and CODABAR
protocols
• Press the Escape key to return to the previous step.
• Press the Space key to set the selected attribute to the default value.
• Refer to the Bar Code Settings table for a list of all available settings.
Attribute
Protocol
Width
Under#
(characters printed
below bar code)
C.Digit
(check digit)
or
key.
Bar Code Settings
CODE39, CODE128, EAN-8, EAN-13,
GS1-128 (UCC / EAN-128), UPC-A, UPC-E, I-2/5 (ITF),
(only available for the CODE39, I-2/5
and CODABAR protocols)
key, and then set a value for that attribute
Value
CODABAR
Small
Large
On
Off
Off
On
Creating a Bar Code Label
1
2
3
4
5
6
7
8
9
50