Paper Sensor - Epson L60IIP - TM B/W Direct Thermal Printer Information Manual

Paper Sensor Commands
The TM-L60II/L60IIP printers support the following commands for controlling the paper sensor(s)
that stop printing and output paper-end signals:
Command Name
Select paper sensor(s) to stop printing
ESC c 4
ESC c 3 Select paper sensor(s) to output paper-end signals
ESC c 4 n
[Name] Select paper sensor(s) to stop printing
[Format] ASCII
Hex
Decimal
[Range] 0 n
ESC c 4 n selects the paper sensor that stops printing when the paper runs out. The default setting is
when all paper sensors are disabled (n=0). Bits 0 and 1 indicate the same sensor. If one of the bits is
enabled, the paper roll near-end sensor is selected to stop printing. The paper roll sensor is always
enabled, and when a paper-end is detected, the printer stops printing.
When the paper roll near-end sensor is enabled, and if the sensor detects a near-end condition during
printing, the printer stops printing and goes off-line automatically after the current printing.
Replacing a new paper roll starts the printing again.
When the paper roll near-end sensor is disabled, and if a paper near-end condition is detected during
printing, the PAPER OUT LED comes on, but the printer does not stop printing and does not go off-
line.
The paper sensor(s) used to stop printing are selected by using n as follows:
Bit Off/On Hex Decimal
Off 00 0
0
On 01 1
Off 00 0
1
On 02 2
2-7 - - -
PRINT #1, CHR$(&H1B);"c4";CHR$(1);
1-26 Command Descriptions
ESC c
1B 63
27 99
5
Function
Paper roll near-end sensor disabled.
Paper roll near-end sensor enabled.
Paper roll near-end sensor disabled.
Paper roll near-end sensor enabled.
Undefined.
Program Example
Paper roll near-end sensor enabled
4 n
34 n
52 n
Rev. A