ZyXEL Communications P-791R V2 Support Notes page 37

• Set the Internet gateway to P-791R v2
(2) PPTP client setup (Win9x or above)
Add one VPN connection from Dial-Up Networking by entering the correct
username & password and the IP address of the P-791R v2's Internet IP
address for logging to NT RAS server.
• Set the Internet gateway to the router that is connecting to ISP
(3) P-791R v2 setup
• Before making a VPN connection from Win9x to WinNT server, you
need to connect P-791R v2 router to your ISP first.
• Enter the IP address of the PPTP server (WinNT server) and the port
number for PPTP as shown below:
Select service name as 'PPTP', fill in the Server IP Address, then press button
'Add'.
When you have finished the above settings, you can ping to the remote Win9x
client from WinNT. This ping command is used to demonstrate that remote
the Win9x can be reached across the Internet. If the Internet connection
between two LANs is achievable, you can place a VPN call from the remote
Win9x client.
For example: C:\ping 203.66.113.2
When a dial-up connection to ISP is established, a default gateway is assigned
to the router traffic through that connection. Therefore, the output below shows
the default gateway of the Win9x client after the dial-up connection has been
established.
All contents copyright © 2007 ZyXEL Communications Corporation.
P-791R v2 Support Notes
37