Xante Accel-a-Writer 8300 Introduction Manual page 34

4. Prepare media following the recommendations in "The Manual
Feed Tray" in chapter 7 (approximately 3/8" [9 mm] or less).
5. Slide the media into the manual feed tray with the printing side
up, leading edge first (fig. 2.33).
Caution: Make sure the paper stack does not exceed the
upper paper limit indicated by tabs on the tray's
side paper guides (fig. 2.33). Overloading the tray
may cause paper jams.
Paper Limit Mark
Fig. 2.33 Load the Manual feed Tray
6. Adjust the paper guides on each side so they rest lightly
against the paper without causing it to buckle (fig. 2.33).
7. Adjust the paper stop on the output tray if you are using
oversized paper (fig. 2.30).
2-34 Installationbb _________________________________________
Paper Guides
Paper Limit Mark