Rear Panel - Integra CDC-3.4 Instruction Manual

Controls & Connectors

Rear Panel

6
IR
IN
OUT
1 2 3
For detailed information, refer to the pages in parenthe-
sis.
A
ANALOG AUDIO OUTPUT (11, 12)
These RCA/phono connectors can be connected to
the analog audio inputs on a hi-fi amp or AV
receiver.
B
COAXIAL & OPTICAL DIGITAL AUDIO
OUTPUT (11)
These connectors can be used to connect a CD-R,
MiniDisc, DAT recorder, digital amp, or other
equipment with digital inputs.
C
REMOTE CONTROL (11, 12)
These (Remote Interactive) connectors can be
connected to the
gra/Onkyo AV components for interactive control.
To use you must also make analog audio con-
nections (RCA/phono) between the CDC-3.4 and
your other Integra/Onkyo equipment.
8
—Continued
5
RS 232
connectors on your other Inte-
4
AC INLET
COMPACT DISC CHANGER
MODEL NO. CDC- 3.4
RATING:
AC 120 V 60 Hz 10 W
Integra Division of
ONKYO CORPORATION
2 - 1 , NISSHIN-CHO, NEYAGAWA-SHI, OSAKA,
JAPAN MADE IN CHINA
D
AC INLET (14)
The supplied power cord is connected here. The
other end of the power cord should be connected to
a suitable wall outlet.
E
RS 232
This RS-232 port can be connected to an external
controller.
F
IR IN/OUT (13)
The IR IN connector can be used to connect a com-
mercially available IR receiver, which can be used
to pickup signals from the remote controller when
the CDC-3.4 is located in another room, installed in
a rack, or is out of range of the remote controller.
The IR OUT connector can be used to connect a
commercially available IR emitter, which can be
used to pass remote controller signals received by
the IR IN along to other AV components.