Rear Panel - Integra DPC-5.3 Instruction Manual

Control Position and Names

Rear Panel

For operational instructions, see the page indicated in brackets [ ].
RS 232
1
1 RS 232 port
This port is to be used in conjunction with an external controller
to control the operation of the DPC-5.3 using an external device.
2 VIDEO OUTPUT COMPONENT (P
If your TV has component inputs, you can connect a component
video cable to your TV and to your DVD Changer for ideal
video quality. The component video cable only carries the video
signal; remember to connect the left and right audio cables.
If you connect a TV that is compatible with a Progressive scan
signal, you can enjoy both Interlaced and Progressive scan.
3 VIDEO OUTPUT S VIDEO jack [15]
If your TV has a S-Video jack, you can connect an S-Video
cable to your TV and to your DVD Changer for improved video
quality. The S-Video cable only carries the video signal;
remember to connect the left and right audio cables.
4 VIDEO OUTPUT VIDEO jack [14]
Connect a video cable to this jack and to the Video Input jack on
your TV.
VIDEO OUTPUT
COMPONENT
AUDIO DIGITAL OUTPUT
OUTPUT
P
R
VIDEO COAXIAL OPTICAL
P
L
B
Y R
S VIDEO
2 3 4 5 6 7
/P /Y) jacks [15]
R B
IR
IN
OUT
DVD CHANGER
MODEL NO. DPC-5.3
8
5 AUDIO OUTPUT jacks [14, 16]
Insert audio cables (left and rights) to these jacks on your DVD
Changer and to the corresponding Audio Input jacks (left and
right) on your TV or receiver.
6 DIGITAL OUTPUT COAXIAL jack [16]
Use coaxial cable to connect your DVD Changer to an AV
component that features digital input capability. If the
component has a Dobly Digital or DTS decoder, you can enjoy
theater-quality multichannel sound.
7 DIGITAL OUTPUT OPTICAL jack [16]
Use optical cable to connect your DVD Changer to an AV
component that features digital input capability. If the
component has a Dobly Digital or DTS decoder, you can enjoy
theater-quality multichannel sound.
8 IR IN/OUT jacks [37]
If the DPC-5.3 is located inside a rack or cabinet that will not
allow infrared beams to reach the IR sensor, you will need to
connect a remote sensor to IR IN jack to be able to use the
remote controller. Then install the remote sensor in an
unblocked location where you can easily point the remote
controller.
Using a mini-jack connector, connect IR emitter to the IR OUT
jack on the DPC-5.3 and then place the IR emitter on the remote
sensor of the component or facing it. Refer to page 37.
9 AC INLET [17]
Use to connect the power cord to the wall outlet.
AC INLET
9
11