Rear Panel - Integra DPC-7.9 Instruction Manual

Controls & Connectors—Continued

Rear Panel

1 2
4
A
RS 232
This port is for servicing.
B
IR IN/OUT (23)
The IR IN connector can be used to connect a com-
mercially available IR receiver, which can be used
to pickup signals from the remote controller when
the DPC-7.9 is located in another room, installed in
a rack, or is out of range of the remote controller
The IR OUT connector can be used to connect a
commercially available IR emitter, which can be
used to pass remote controller signals received by
the IR IN along to other AV components.
C
COMPONENT 2 VIDEO OUTPUT
These BNC connectors can be used to connect a TV
or projector with BNC component video inputs.
The DPC-7.9 has two component video outputs, the
COMPONENT 1 and COMPONENT 2, however,
they output the same video signal.
D
ANALOG AUDIO OUTPUT
These RCA/phono connectors can be connected to
the analog audio inputs on your TV, hi-fi amp, AV
receiver. There are two sets of outputs. You could
connect one set to your AV receiver, the other to your
TV for those occasions when you want to watch a
DVD-Video but don't want to use your AV receiver.
The DPC-7.9 has two pairs of stereo analog audio
output connectors. They output the same audio sig-
nal respectively.
E
REMOTE CONTROL
These (Remote Interactive) connectors can be
connected to the
gra/Onkyo AV components for interactive control.
If you're using RIHD, do not connect anything to
these connectors.
F
OPTICAL AUDIO OUTPUT
This optical digital audio output can be connected to
an optical digital audio input on a hi-fi amp, AV
receiver, or surround sound decoder (Dolby Digital,
DTS).
14
3
5 6 7 8 9 J K
connectors on your other Inte-
G
COAXIAL AUDIO OUTPUT
This coaxial digital audio output can be connected
to a coaxial digital audio input on a hi-fi amp, AV
receiver, or surround sound decoder (Dolby Digital,
DTS).
H
HDMI OUT
This HDMI jack outputs digital video and audio and
can be connected to an HDMI input on a compatible
TV or other component.
I
S VIDEO OUTPUT
These connectors can be used to connect TVs or
projectors with S-Video inputs.
The DPC-7.9 has two S-Video output connectors.
They output the same video signal.
J
VIDEO OUTPUT
These RCA/phono connectors can be used to con-
nect TVs or projectors with composite video inputs.
The DPC-7.9 has two composite video output con-
nectors. They output the same video signal respec-
tively.
K
COMPONENT 1 VIDEO OUTPUT
These RCA/phono connectors can be used to con-
nect a TV or projector with RCA/phono component
video inputs.
The DPC-7.9 has two component video outputs, the
COMPONENT 1 and COMPONENT 2, however,
they output the same video signal.
L
AC INLET
The supplied power cord connects to this polarized
inlet. The other end of the power cord should be
connected to a suitable wall outlet. On the Austra-
lian model, the power cord is not polarized.
See page 19–22 for connection information.
L