Rear Panel - Integra DPT-1 Instruction Manual

Rear Panel

1
2
3
4
5
6
7
8
1
VIDEO OUT jack
Connect the VIDEO OUT jack to the video input on a
TV or monitor or to an AV component with video input
capability. When using this jack, be sure to set VIDEO
SELECT to the top position (pages 15 and 18).
2
VIDEO IN jack
Connect the VIDEO IN jack to the video output of
another DPT-1 changer or another component with
video output capability (pages 67).
3
S-VIDEO OUT jack
If your TV or monitor has an S-video input, clear
picture reproduction is possible by connecting the
S-VIDEO OUT jack to your TV or monitor using a
commercially available S-video cable. When using
this jack, be sure to set VIDEO SELECT to the top
position (pages 16 and 18).
4
S-VIDEO IN jack
Connect the S-VIDEO IN jack to another DPT-1
changer or component with S-video output capability
(pages 67).
5
VIDEO SELECT switch
Use to set which output is used to output the video
signals. Set to the top position for composite video
and S-video output and to the bottom position for
component video output (pages 15, 16, and 18).
6
COMPONENT VIDEO OUT jacks
If your TV, projection monitor, projector, or similar
component has component video inputs, you can
produce a high quality picture by connecting to the
component video outputs on this unit. When using
these jacks, be sure to set VIDEO SELECT to the
bottom position (page 18).
14
UDD1N
VNA2176
27122711
OUT
VIDEO
IN
OUT
MASTER
S VIDEO
MASTER-SLAVE
CONTROL
IN
SLAVE
OUT
VIDEO SELECT
DIGITAL
( OPTICAL )
OUT
DIGITAL
Y P P
B R
( COAXIAL )
COMPONENT
VIDEO OUT
IN
R
L
OUT
AUDIO
IN
7
AUDIO OUT jacks
Connect to the stereo audio inputs of a TV or stereo
AV component. If you are connecting to an AV
component that has both digital and analog input
jacks for DVD player connection, it may be beneficial
to make both connections (pages 15 and 17).
8
AUDIO IN jacks
9
Connect to the analog audio outputs of another
DPT-1 or component with audio output capability
(pages 66).
0
9
MASTER-SLAVE CONTROL jacks
Connect two DPT-1 changers for singular control of
-
both changers and a total of 601 discs. Connect the
MASTER jack on the changer to be used as the
=
"Master" to the SLAVE jack of a second "Slave"
changer using the supplied Master-Slave control
cord. Do not attempt to make connections to other
components using this jack (page 66).
0
DIGITAL (OPTICAL) OUT jack
Connect the DIGITAL (OPTICAL) OUT to the digital
optical input of an AV component with a
built-in decoder, etc. to output the digital audio signal
recorded on discs. (page 17).
-
DIGITAL (COAXIAL) OUT jack
Connect the DIGITAL (COAXIAL) OUT to the digital
coaxial input of an AV component to output the digital
audio signal recorded on discs (pages 16 and 17).
=
DIGITAL (COAXIAL) IN jack
Connect the DIGITAL (COAXIAL) IN jack of another
DPT-1 changer or another component with digital
output (coaxial) capability (pages 66).
INTERFACE CONNECTOR jack
This jack is intended for use by a system
commander in the integration of some systems.
Normally, this jack is not used.
INTERFACE
CONNECTOR