Belt Replacement - Hoover U9145 Owner's Manual

F
16

Belt replacement

Inspect the belt
The powered hand tool belt is designed to last a long time and is not
normally replaced. However, if the belt is cracked, gouged or broken,
it should be replaced.
Replace belt
When replacing belt, ask for HOOVER part No. 38528037.
1. Remove bottom plate, belt guard and brush roll as described in
E
Figs. 31 through 33.
The belt can be seen by removing the bottom plate and belt guard
(Figs. 31 and 32).
37
38
5. Replace brush roll, belt guard, and bottom plate as described in
Figs. 33 through 36.
H
G
Powered hand tool (cont'd)
2. Grasp turbine (E) and pull firmly to remove.
3. Remove belt from turbine pulley (F). Replace with new belt.
4. With flat sides of turbine retainers (G) pointing down, slide
retainers into grooves (H) in tool housing and snap into place.