Cleaning Filters; Replacing Belt; Belt Replacement; How To Clean - Hoover TurboPOWER WindTunnel S3646 Owner's Manual

3-2
Carefully pull out used bag.
Slide bag collar of new bag firmly into
holder.
Fit sides of bag into bag cavity below
seal (A).
Clear bag opening (B) by pushing the
pierced paper through opening toward
3-5
Filters-
secondary and micro

How to clean

Disconnect cleaner from electrical
outlet.
The secondary filter, located behind the
grill in the bag compartment, protects
3-8
What to buy
There are other belts manufactured that
are similar in shape and size, but are not
8
3-3
bag interior.
Close bag lid.
3-6
the motor from dirt particles. If filter be-
comes dirty, pull off grill and lift out filter.
Wash filter in warm water or replace it
with a new one. A dry filter must be put
back into cleaner.
Do not operate cleaner without sec-
ondary filter in place.
The micro filter aids in the filtration pro-
cess to return clean air to the room. To
remove this filter, open tool lid, remove
dusting brush and pull up red filter cas-
sette.
If filter is dirty, open grid on cassette and
remove filter. Wash filter in warm water
or replace it with a new one. A dry filter
designed for the HOOVER power nozzle.
Such belts do not operate the agitator
correctly and may create stress which
could damage your power nozzle. Use
only a genuine HOOVER Belt part no.
40201180 when a belt replacement is
necessary.
When to replace
The belt should be checked from time
to time to be sure it is in good condi-
tion. To check, remove the hood (see
following section). Replace the belt if it is
stretched, cut, or broken.
How to replace
Disconnect cleaner from electrical
outlet and disconnect power nozzle
3-4
How to attach bag lid
The bag lid and hinges are designed
with a "break- away" feature. If the lid is
pushed open too far, it will come off. It
can be easily re-attached by aligning the
hinges with the appropriate slots in the
cleaner, as shown.
3-7
must be put back into cleaner.

Belt replacement

The belt in your power nozzle drives the
agitator. It has been designed specifical-
ly for use in this cleaner and is important
for effective operation.
from extension wands.
To remove hood, turn nozzle over and
unscrew the 4 recessed Phillips head
screws.
Note: Do not remove the 3 screws in
the triangle formation as these hold
the motor in place.
A
B