HOOVER FoldAway Thank you for your purchase! ® Upright ™ Owner’s Manual ENGLISH pp. 1-12 ESPAÑOL pág. 15-21 FRANÇAIS p. 22-28 ®...
• Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, take it to a Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer (Depot).
If you need any assistance: Visit our website at www.hoover.com. Click on the “Service” button to find the service outlet nearest you OR Call 1-800-944-9200 for an automated referral of service outlet locations (U.S. only) OR Call 1-330-499-9499 to speak with a representative in our Consumer Response Center.
2. How to use Cleaner description Operate cleaner only at voltage specified on data plate on bottom of cleaner. This cleaner is intended for household use. Polarized plug To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other).
Transporting cleaner Put handle in upright position. Tilt cleaner back on rear wheels. Push forward. Settings For maximum cleaning performance, the following carpet height settings are recommended. • Low setting: for all types of carpet and hard floors. Note: If the cleaner is difficult to push, rotate knob to the next higher setting.
Cleaning tools Tools allow for cleaning surfaces above the floor and for reaching hard to clean areas. The cleaner is ready for tool use when handle is in upright position. CAUTION: Agitator continues to rotate while cleaner handle is in upright position.
3. Maintenance Familiarize yourself with these home maintenance tasks as proper use and care of your cleaner will ensure contin- ued cleaning effectiveness. Dirt cup The dirt cup assembly consists of the following parts: Dirt cup (A) Filter chamber (B) Pleated filter (C) Lid (D) Dirt cup carry handle/latch (E)
Be certain that the dirt cup is locked in the correct position. Headlight replacement What to buy This cleaner uses a 12 volt, wedge base type 912 bulb, HOOVER part No. 27313107. 3-14 Disconnect cleaner from electrical outlet. Remove dirt cup as described in Fig.
Belt replacement The belt on your Hoover cleaner causes the agitator to rotate and is important for the effective operation of the cleaner. The belt is located under the hood of the cleaner and should be checked from time to time to be sure it is in good con- dition.
What to buy When purchasing a new agitator, ask for 13” - HOOVER part no. 48414110 15” - HOOVER part no. 48414115. 3-28 3-26 Replace hood, 2 screws and hose.
• calling 1-800-944-9200 for an automated referral of authorized service outlet locations (U.S. only). Do not send your cleaner to The Hoover Company in North Canton for service, this will only result in delay. If further assistance is needed, contact...
The Hoover Company on-line at www.hoover.com This warranty does not cover pick up, delivery, or house calls; however, if you mail your appliance to a Hoover Factory Service Center for warranty service, transportation will be paid one way. While this warranty gives you specific...