Replacing Belt; Replacing Headlight; Belt Replacement - Hoover TurboPOWER Owner's Manual

3-3
C
Replacing bag door
To replace bag door, lift up lower edge of
filter bag. Insert the 3 tabs (C) on bottom
of bag door into the 3 slots on bag
c o m p a rtment.
Make sure all edges of filter bag are
c o m p l e t e ly inside the bag compart m e n t .
Close door.

Belt replacement

The belt on your HOOVER cleaner
causes the agitator to rotate and is
important for the effective operation of
the cleaner. The belt is located under
the bottom plate of the cleaner and
should be checked from time to time
to be sure it is in good condition.
When to replace
To check belt, remove bottom plate as
shown in "How to replace." Replace
belt if it is stretched, cut or broken.
What to buy
One extra belt has been provided with
your cleaner.
To assure effective operation, use only
genuine HOOVER belts with your
cleaner. When purchasing a new belt,
ask for Hoover part No. 38528-027.
3-8
E
D
Positioning belt and agitator
Slip agitator through new belt (with let-
tering toward outside of cleaner) and
position belt in belt guide (C).
10
Headlight
3-4
What to buy
This cleaner uses a 12 volt, wedge base
type 912 bulb, Hoover part No. 27313-
101.
How to replace
Disconnect cleaner from electrical
outlet.
Removing hood
1. To remove hood, refer to Figs. 3-10 to
3-12
3-6
A
How to replace
Removing bottom plate
Disconnect cleaner from electrical
outlet.
Place handle in operating position and
turn cleaner over.
To remove bottom plate, insert end of flat
screwdriver into wide area of right-hand
slot (A) and push handle of screwdriver
to the rear. Repeat in left-hand slot (A).
Lift extension of bottom plate (B), rotate
plate and remove from cleaner body.
C
Push end of belt into opening in cleaner
base.
Reposition agitator making sure to align
flat sides of projection (D) on belt end of
agitator with flat sides of slot (E) in clean-
er base.
3-5
2. Remove bulb by pulling straight out
of socket; push new bulb into socket
until it locks in place.
3. Place hood on cleaner body and
press firmly to snap all four latches. Pull
up on hood slightly to make sure all four
latches are secured.
4. Push carpet height control back onto
front of cleaner.
3-7
B
A
Removing used belt
Remove agitator brush roll and broken
belt.
(If belt is not broken but is stretched or
cut, proceed with Figs 3-10 to 3-12 and
pull belt off motor pulley. Then continue
with Fig 3-8.)
3-9
Replacing bottom plate
Place the three tabs on bottom plate
into slots in front of cleaner base. Snap
bottom plate into place over agitator.