Using Tools - Hoover U9145 Owner's Manual

Troubleshooting, cont'd.
If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the check list below.
What's the problem?
What's the cause?
Not firmly plugged in.
No voltage in wall plug.
What's the problem?
What's the cause?
Hard Surface mode selected on control panel.
Agitator is obstructed.
What's the problem?
What's the cause?
Dirt cup full.
Pre-filter screen dirty.
Incorrect carpet height setting.
Blockage in system.
What's the problem?
What's the cause?
Incorrect carpet height setting.
What's the problem?
What's the cause?
Dirt cup full.
Pre-filter screen dirty.
Gentle brush mode selected.
Blockage in system.
What's the problem?
What's the cause?
Too much pressure being applied to tool.
Blockage in turbine channel.
Broken or worn belt.
Low cleaner suction.
Pre-filter screen dirty.
Cleaner won't turn on.
Agitator brushes aren't turning.
Cleaner won't pick up.
Cleaner hard to push.
Cleaning tools won't pick up.
Powered hand tool brush roll won't turn.
What's the solution?
Plug unit in firmly.
Replace fuse or reset circuit.
What's the solution?
Select a suitable carpet mode setting.
Disconnect cleaner from electrical outlet. Turn cleaner over and
remove any debris that has accumulated on the agitator brush
roll. Do not attempt to remove the agitator brush roll.
What's the solution?
Disconnect cleaner from electrical outlet. Empty dirt cup.
Disconnect cleaner from electrical outlet. Clean the pre-filter
screen using the dusting brush tool.
Select another carpet height setting on the control panel.
Clear blockage (see "Clearing blockages" section).
What's the solution?
Select a higher carpet height setting on the control panel.
What's the solution?
Disconnect cleaner from electrical outlet. Empty dirt cup.
Disconnect cleaner from electrical outlet. Clean the pre-filter
screen using the dusting brush tool.
De-select gentle brush mode on the control panel.
Clear blockage (see "Clearing blockages" section).
What's the solution?
Continue using tool applying light pressure.
Remove blockage.
Replace belt.
Refer to items under "Cleaner won't pick up".
Disconnect cleaner from electrical outlet. Clean the pre-filter
screen using the dusting brush tool.
19
(Cont'd)