Table of Contents
Advertisement
Switching the INPUT
Mode
Select the appropriate input mode for the con-
nected equipment.
Press
,
,
mote control to select the input mode.
• • • • • When pressing '
' '
' ' or "
mode switches in order of :
INPUT 1
INPUT 2
Note
• When no signal is received, "NO SIGNAL"
will be displayed. When a signal that the
projector is not preset to receive is received,
"NOT REG." will be displayed.
• The INPUT mode is not displayed when
"OSD Display" of the "Options1" menu is set
to "
" (OFF). (See page 51.)
About the INPUT mode
INPUT 1/
Used for projecting images from
INPUT 2
equipment that sends RGB sig-
(RGB/
nals or component signals con-
Component)
nected to the RGB input terminal.
INPUT 3
Used for projecting images
(Video)
from equipment connected to
the VIDEO input terminal.
INPUT 4
Used for projecting images
(S-Video)
from equipment connected to
the S-VIDEO input terminal.
Adjusting the Volume
Press \ \ \ \ \ /| | | | | on the projector or VOL
/
on the remote control to ad-
just the volume.
Note
or \ will lower the volume.
• Pressing
or | will raise the volume.
Pressing
or
on the re-
" " on the projector, input
" "
INPUT 3
INPUT 4
"On-screen Display of INPUT Mode (Example)
INPUT 1/2 mode
Using RGB
Using
Component
INPUT 3 mode
Using Video
INPUT 4 mode
Using S-Video
"On-screen Display
/
/
/
INPUT buttons
Volume buttons
33
Advertisement
Table of Contents
