Controlling The Projector By A Computer - Eiki EIP-3500 Owner's Manual

Controlling the Projector by a Computer

When the RS-232C terminal on the projector is connected to a computer with a DIN-D-sub RS-232C adaptor
and an RS-232C serial control cable (cross type, commercially available), the computer can be used to control
the projector and check the status of the projector. Refer to the "SETUP GUIDE" contained on the supplied
CD-ROM for details.
When connecting to a computer using an RS-232C serial control cable and a DIN-D-sub RS-232C adaptor
Computer
RS-232C serial control cable (cross type, commercially available)
Note
• The RS-232C function may not operate if your computer terminal is not correctly set up. Refer to the
operation manual of the computer for details.
• Refer to page 4 of the "SETUP GUIDE" contained on the supplied CD-ROM for "RS-232C Specifica-
tions and Commands".
Info
• Do not connect the RS-232C cable to a port other than the RS-232C terminal on the computer. This may
damage your computer or projector.
• Do not connect or disconnect an RS-232C serial control cable to or from the computer while it is on. This
may damage your computer.
When connecting to the LAN terminal using a LAN cable
HUB
or
Computer
LAN cable (Category 5 type, commercially available)
Note
• When connecting to hub, use straight-through Category 5 (CAT.5) type cable (commercially available).
• When connecting to computer, use cross-over Category 5 (CAT.5) type cable (commercially available).
To RS-232C terminal
DIN-D-sub
RS-232C adaptor
To RS-232C terminal
Supplied
acces-
sory
TX/RX LED (yellow)
Illuminates when transmitting/receiving data.
LINK LED (green)
Illuminates when linked.
* To ensure safety, do not connect the
LAN terminal with any cables such
as a telephone line that may cause
excessive voltage.
To LAN terminal
DIN-D-sub
RS-232C
adaptor
27