Connecting The Power Cord - Eiki EIP-3000N Owner's Manual

When connecting to the LAN terminal using a LAN cable
Hub
or
Computer
Note
• When connecting to a hub, use a straight-through Category 5 (CAT.5) type cable (commercially
available).
• When connecting to a computer, use a cross-over Category 5 (CAT.5) type cable (commercially
available).

Connecting the Power Cord

Plug the supplied power cord into the
AC socket on the rear of the projector.
Then plug into AC outlet.
LAN cable (Category 5 type,
commercially available)
TX/RX LED (yellow)
Illuminates when transmit-
ting/receiving data.
LINK LED (green)
Illuminates when linked.
* To ensure safety, do not
connect the LAN terminal
with any cables that may
cause excessive voltage
such as a telephone line.
To LAN terminal
Supplied
accessory
AC socket
Power cord
To AC outlet
27