Connecting To A Computer - Eiki EIP-3000N Owner's Manual

Connecting to a Computer

Before connecting, ensure that the power cord of the projector is unplugged from the AC
outlet and turn off the devices to be connected. After making all connections, turn on the
projector and then the other devices. When connecting a computer, ensure that it is the last
device to be turned on after all the connections are made.
Ensure that you have read the owner's manuals of the devices to be connected before making
connections.
To audio output terminal
To RGB output terminal
* ø3.5 mm stereo or
mono audio cable
(commercially
available)
* When using the ø3.5 mm mono audio cable, the volume level will be half of
Note
• See page 58 "Computer Compatibility Chart" for a list of computer signals compatible with the projec-
tor. Use with computer signals other than those listed may cause some of the functions to not work.
• A Macintosh adaptor may be required for use with some Macintosh computers. Contact your near-
est Macintosh Dealer.
• Depending on the computer you are using, an image may not be projected unless the
computer's external output port is switched on. Refer to the specific instructions in the owner's
manual of your computer to enable your computer's external output port.
Computer
RGB Cable
when using the ø3.5 mm stereo audio cable.
Supplied
accessory
To INPUT1 terminal
RGB Cable
To AUDIO
(INPUT1, 2)
terminal
23