Initial Margin Shift Setting; Erase Width Adjustment; Card Shot Settings; Setting A Maximum Number Of Copies - Sharp MX-M450NA Administration Manual

Administrator settings guide
Table of Contents

Advertisement

COPY SETTINGS

Initial margin shift setting

This setting is used to set the initial margin shift
amount.
The initial margin shift amount can be set from 0 mm to
20 mm (0" to 1") in increments of 1 mm (1/8").
Normally the margin shift is set to 10 mm (1/2") for both
the front and back of the paper.

Erase width adjustment

This setting is used to set the initial width of edge erase
copying.
The edge erase width can be set from 0 mm to 20 mm
(0" to 1") in increments of 1 mm (1/8").
The edge erase and centre erase widths are normally
set to 10 mm (1/2").

Card shot settings

This setting is used to set the initial original size for the
card shot function.
Enter the X dimension (width) first and then the Y
dimension (length).
Both the X and Y dimensions can be set from 25 mm to
210 mm (1" to 8-1/2") in increments of 1 mm (1/8").

Setting a maximum number of copies

This setting is used to set the maximum number of
copies that are allowed per original.
Any number from 1 to 999 can be set for the maximum.
The maximum number of copies is initially set to 999.

Disabling deletion of job programs

This setting is used to prohibit the deletion and
changing of copy settings stored in job programs.

Disabling of bypass-tray in duplex copy

This setting is used to disable the use of the bypass
tray when making duplex copies.
The bypass tray is often used to feed label sheets,
transparency film, and other special papers for which
two-sided copying is prohibited. If one of these special
papers enters the reversing unit, a misfeed or damage
to the unit may result. If special media for which
two-sided copying is prohibited is often used, it is
recommended that you enable this setting.

Disabling of auto paper selection

This setting is used to disable the auto paper selection
function.
When this setting is enabled, paper that is the same
size as the original placed on the document glass or in
the automatic document feeder is not automatically
selected.
17

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MX-M450NA and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Mx-m450nMx-m350n

Table of Contents