Table of Contents
Advertisement
GENERAL SETTINGS
Tandem setting
This setting is used to configure the IP address and
port number of the client printer when you wish to have
two machines (which are used as TCP/IP network
printers) print in tandem.
The factory default setting for the port number is
[50001]. Unless you experience difficulty with this
setting, it does not need to be changed.
The tandem function can also be prohibited, or the
reception of tandem data from the other machine can
be prohibited. (Normally this is not necessary.)
To prohibit the tandem function, select "DISABLING
OF MASTER MACHINE MODE".
To prohibit reception of tandem data from the other
machine, select "DISABLING OF SLAVE MACHINE
MODE".
NOTE
To use the tandem function when auditing mode is
enabled, the same account number must be entered
on both machines. If the same account number is not
entered, only the server machine may print or the
printed pages may not be added to the correct
account.
PING command
This setting is used to check if the machine and a
computer connected to the network can communicate.
Enter the IP address of the computer that you wish to
check and touch the [START] key. A message will
appear indicating whether or not there was a response
from the computer.
Security settings
The following settings are related to security. Touch the
[SECURITY SETTINGS] key to configure the settings.
SSL setting
SSL can be used for data transmission over a network.
SSL is a protocol that enables the encryption of
information communicated over a network. Encrypting
data makes it possible to transmit and receive sensitive
information safely.
• HTTPS: Apply
SSL
communication.
• IPP-SSL: Apply
SSL
communication.
List print
This setting is used to print lists and reports that can
only be printed from the administrator settings.
• Touch the [ADMINISTRATOR SETTINGS LIST] key
to print one of the following groups:
Copy, printer, fax/image send, document filing,
general, security, all administrator settings lists
• Touch a key other than the [ADMINISTRATOR
SETTINGS LIST] key to begin printing a list or report.
14
encryption
to
HTTP
encryption
to
IPP
Sharp OSA settings
The following settings are related to Sharp OSA. Touch
the [Sharp OSA SETTINGS] key to configure the
settings.
Default display setting
External account setting
Default display setting
The
default
screen
that
[DOCUMENT FILING] key is pressed can be specified.
Select either the base screen of document filing mode
or the external application selection screen. This
setting can only be configured when the application
communication module is installed. The setting also
appears in the document filing settings.
When the [CA] key ([Clear all] key) is pressed in
document filing mode or Sharp OSA mode, the initial
screen of the mode appears, regardless of the default
display setting.
External account setting
When [ENABLE EXTERNAL ACCOUNT CONTROL]
is enabled, the machine enters external count mode.
When
both
[ENABLE
CONTROL] and [ENABLE AUTHENTICATION BY
EXTERNAL SERVER] are enabled, the machine
enters external authentication mode. This item can
only be selected when the external account module is
installed.
Change admin password
This setting is used to change the administrator
password that must be entered to configure the
administrator settings. When the machine is first used,
the administrator should change the administrator
password that was set at the factory to the desired
5-digit code. Only one administrator password can be
set.
The factory default setting for the administrator
password is 00000.
Product key
Use these settings to enter the product keys for the
following options.
PS3 expansion kit
This setting is used to enter the product key for the PS3
expansion kit (this allows the machine to be used as a
PostScript compatible printer).
Ask your dealer for the product key.
Network scanner expansion kit
This setting is used to enter the product key for the
network scanner expansion kit.
Ask your dealer for the product key.
appears
when
the
EXTERNAL
ACCOUNT
Advertisement
Table of Contents
