Table of Contents
Advertisement
Available languages
Available languages
CONNeCT VeNT
29.
Connect vent to exhaust outlet
Using a 4" (102 mm) clamp, connect vent to exhaust outlet
in dryer. If connecting to existing vent, make sure vent is clean.
Dryer vent must fit over dryer exhaust outlet and inside exhaust
hood. Check that vent is secured to exhaust hood with a 4"
(102 mm) clamp.
30.
Move dryer to final location
Move dryer to final location, taking care not to crush or kink vent.
After dryer is in place, remove corner posts and cardboard from
under dryer.
12
LeVeL Dryer
31.
Level Dryer
Place
level here
Check levelness of dryer from side to side. Repeat from
front to back.
Not Level
32.
Tighten and adjust leveling legs
If dryer is not level, prop up using a wood block, use wrench
to adjust legs up or down, and check again for levelness. Once
legs are level, make sure all four legs are snug against the
ground before tightening them.
COMPLeTe INSTaLLaTION
CHeCKLIST
q
Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
q
Check that you have all of your tools.
q
Dispose of/recycle all packaging materials.
q
Check dryer's final location. Be sure vent is not crushed
or kinked.
LEVEL
Not Level
Advertisement
Table of Contents
