Table of Contents
Advertisement
Available languages
Available languages
INSTaLLaTION reQUIreMeNTS
TOOLS AND PARTS
Gather the required tools and parts before starting installation.
Tools needed for all installations:
Flat-blade screwdriver
Wire stripper (direct wire
installations)
1/4" nut driver
(recommended)
Tape measure
Level
Adjustable wrench that
opens to 1" (25mm) or
hex-head socket wrench
#2 Phillips screwdriver
Tin snips (new vent
installations)
Vent clamps
Pliers
Caulking gun and compound
(for installing new exhaust vent)
Tools needed for gas installations:
8" or 10" pipe wrench
Pipe-joint compound
resistant to LP gas
Parts supplied (non-steam models):
Leveling legs (4)
Parts package is located in dryer drum. Check that all parts
are included.
NOTE: Do not use if installing dryer on pedestal.
Check local codes. Check existing electrical supply and venting.
See "Electrical Requirements" and "Venting Requirements"
before purchasing parts.
Check code requirements. Some codes limit, or do not permit,
installing dryer in garages, closets, mobile homes, or sleeping
quarters. Contact your local building inspector.
Optional Equipment:
(Not supplied with washer)
Refer to your Use and Care Guide for information about
accessories available for your dryer.
8" or 10" adjustable wrench
(for gas connections)
3
Advertisement
Table of Contents
