Table of Contents
Advertisement
Available languages
Available languages
Mobile home - Additional installation requirements:
This dryer is suitable for mobile home installations. The
installation must conform to the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280
(formerly the Federal Standard for Mobile home construction
and Safety, Title 24, HUD Part 280) or Standard CAN/CSA-Z240
MH.
Mobile home installations require:
All dryers:
Metal exhaust system hardware, available for purchase from
n
your dealer. For further information, see "Assistance or
Service" section in your Use and Care Guide.
Special provisions must be made in mobile homes to
n
introduce outside air into dryer. Openings (such as a nearby
window) should be at least twice as large as dryer exhaust
opening.
For gas dryers:
Mobile Home Installation Kit Part Number 346764.
n
LOCaTION reQUIreMeNTS
DRYER DIMENSIONS
Front view:
3
"
35
/
8
(899 mm)
*
3
"
/
4
(18 mm)
* Approx. measurement
4
27"
(686 mm)
Side view:
(736 mm)
right side
6
(173.5 mm)
Back view:
NOTE: Most installations require a minimum of 5" (127 mm)
clearance behind dryer for exhaust vent with elbow. See
"Venting Requirements."
IMPORTANT: Do not operate, install, or store dryer where
it will be exposed to water, weather, or at temperatures below
45° F (7° C). Lower temperatures may cause dryer not to
shut off at end of automatic sensor cycles, resulting in longer
drying times.
29"
Left or
exhaust
7
/
"
8
1
6
(159 mm)
Electric
1
3
/
(89 mm)
14"
(358 mm)
1
3
/
"
2
(89 mm)
/
"
4
1
28
/
"
8
(715 mm)
"
2
Advertisement
Table of Contents
