Connecting The Antennas; Preparing For Surround Sound; Speaker Settings - Kenwood VRS-5100 Instruction Manual

Setting up the system

Connecting the antennas

AM loop antenna
The supplied loop antenna is for use indoors. Place it as far as possible
from the receiver, TV set, speaker cords and power cord, and adjust
the direction for best reception.
AM antenna terminal connections
1 Push lever. 2 Insert cord.
FM indoor antenna
The supplied indoor antenna is for temporary use only. For stable
signal reception we recommend using an outdoor antenna. Disconnect
the indoor antenna when you connect one outdoors.
FM antenna terminal connections
Insert antenna adapter.
FM outdoor antenna
Lead the 75Ω coaxial cable connected to the FM outdoor antenna into
the room and connect it to the FM 75Ω terminal.
DVD
SPEAKERS (6 – 16Ω)
SURR BACK CENTER REAR FRONT
/SW R L R L
AM
VIDEO2
GND
VIDEO1
FM
75Ω
R
ANTENNA
AM
GND
FM
75Ω
ANTENNA
Use an antenna
adapter
(Commercially
available)
14 EN
3 Release lever.
SUB WOOFER
DVD
PRE
IN MONITOR
OUT VOLTAGE SELECTOR
OUT
SURR BACK OPTICAL AC220- AC110-
VIDEO1
DE-EMPHASIS
240V~ 120V~
CHANNEL SPACE
VIDEO2
75µs
IN
/L AM10kHz
R BS FM100kHz
VIDEO2
COAXIAL
AC 110-120V
VIDEO1 /220-240V~
L R L
MONITOR DVD 50/60Hz
IN OUT IN OUT
OUT
AUDIO
S VIDEO VIDEO DIGITAL IN
Attach to the stand
AM loop antenna
Insert terminals and
tighten screws
FM indoor antenna
FM outdoor antenna

Preparing for surround sound

Speaker settings

To enable you to obtain optimum enjoyment from the amplifier's listen-
ing modes, make sure to complete the speaker settings (Subwoofer,
Front, Center, Surround and Surround Back speakers) as described
below.
ON/STANDBY
only for the U.S.A. and Canada
If you purchase HTB system, you may skip step 2 to 4.
Original settings of this Receiver are adjusted to system
speakers.
The original settings are
6ch AMP : BS/SW SW
Front
50µs
AM9kHz
FM50kHz
Surround : SURR NML
W
Subwoofer Re-Mix : REMIX ON
1
Turn on the power to this amplifier by pressing the ON/
STANDBY
2
Press the SETUP key to enter the SETUP mode.
Use the MULTI CONTROL∞¥5 keys or TRIM∞¥5 keys to select
the "SP SETUP"
1 SP SETUP
2 TEST TONE
3 DISTANCE
4 SP EQ
5 DIMMER
6 EXIT
3
Press the SETUP key to select the 6ch AMP setting.
The Surround Back and Subwoofer output selections are displayed
as follows:
1 BS/SW SW
2 BS/SW BS
3 BS/SW OFF
Use the MULTI CONTROL∞¥5 keys or TRIM∞/5 keys to select the
speakers.
Press the SETUP key to proceed to the next SETUP selection.
MULTI CONTROL∞¥5
SETUP
POWER
SETUP
Subwoofer
: FRNT LRG Center
Surround Back
key or POWER key.
: SW/BS speaker terminal will output
Subwoofer sound.
: SW/BS speaker terminal will output Sur-
round Back sound. SW PREOUT will have
output from SW only.
: It is not advisable to use SW/BS speaker
terminal for this selection.
TRIM∞¥5
: SW ON
: CNTR NML
: BS NML