Connecting Audio And Digital Signals - Kenwood VRS-5100 Instruction Manual

Setting up the system

Connecting audio and digital signals

The digital in jacks can accept DTS, Dolby Digital, or PCM signals. Connect components capable of outputting DTS, Dolby Digital, or standard PCM (CD)
format digital signals.
If you have connected any digital components to the receiver, be sure to read the "Input mode settings" section carefully.
SPEAKERS (6 – 16Ω)
SURR BACK CENTER
/SW
CAUTION
Be sure to adhere to the following, or proper ventilation will be blocked causing damage or fire hazard.
• Do not place any object impairing heat radiation onto the top of the unit.
• Leave a space around the unit (from the largest outside dimension including projection) equal or greater than, shown below.
Top panel : 50 cm
DVD
REAR FRONT
R L R L
AM
VIDEO2
GND
VIDEO1
FM
75Ω
R
IN
ANTENNA
DVD
VIDEO2
VIDEO1
R L R
IN OUT
AUDIO
Audio IN
Audio OUT
Satellite or component
with DTS, Dolby Digital,
Audio OUT
or PCM DIGITAL OUT
Audio OUT
DVD Player or CD Player
Side panel : 10 cm
SUB WOOFER
DVD
PRE
IN
MONITOR
OUT
OUT
SURR BACK
VIDEO2
IN
/L
R
BS
VIDEO1
L R L MONITOR
OUT IN OUT
OUT
AUDIO S VIDEO VIDEO
SUB WOOFER
PRE
OUT
SURR BACK
L
Optical fiber
cable
OPTICAL DIGITAL
Video deck
OUT (AUDIO)
Optical fiber cable
OPTICAL DIGITAL OUT
Coaxial cable
DIGITAL OUT (AUDIO)
VOLTAGE SELECTOR
OPTICAL
VIDEO1 AC220- AC110-
DE-EMPHASIS
240V~ 120V~
CHANNEL SPACE
75µs 50µs
AM10kHz AM9kHz
FM100kHz FM50kHz
VIDEO2
COAXIAL
AC 110-120V
/220-240V~
DVD
50/60Hz
W
DIGITAL IN
OPTICAL
VIDEO1
VIDEO2
COAXIAL
DVD
DIGITAL IN
(AUDIO)
Back panel : 10 cm
8
To AC wall outlet
9
EN