Linux Installation: Initial; Installation Wizard: Enable Vcem Server Enclosure Discovery - HP 8/20q User Manual

T
Figure 4

Installation wizard: Enable VCEM Server Enclosure Discovery

Repeat this procedure to install the software on additional Windows servers.

Linux installation: initial

Follow these steps to install the required software on servers running Linux.
NOTE: To configure servers using other operating systems or non-QLogic HBAs, see
SAN Connection Manager for HP-UX and Emulex HBAs,"
To install the components required by Simple SAN Connection Manager on Linux:
1. Insert the installation CD into the CD-ROM drive of the server.
The installation CD should mount automatically in one of the following locations:
/media/cdrom/
/mnt/cdrom/
/media/cdrecorder/
If the installation CD is not mounted automatically, issue the following commands to mount the CD:
# mkdir -p /mnt/cdrom
# mount /dev/cdrom /mnt/cdrom
IMPORTANT:
using the following CD label:
# /media/HpInstallx.x/
If this occurs, the CD may get mounted with the no execution flag, causing the installation script
to fail. Installation failure may be indicated by the following error message:
# ./install_smb.sh
The following is returned:
bash: ./install_smb.sh: /bin/sh: bad interpreter: Permission denied
Under specific distributions, such as RHEL 5, the installation CD is auto-mounted
HP StorageWorks Simple SAN Connection Manager User Guide
page 17.
"Configuring Simple
15