HP 8/20q User Manual page 142

Hp storageworks simple san connection manager user guide (5697-0633, november 2010)
Hide thumbs Also See for 8/20q:
Table of Contents

Advertisement

When I open Simple SAN Connection Manager, why doesn't it discover my subsystems?
Symptoms:
Solution:
Why doesn't Simple SAN Connection Manager start up?
Symptoms:
Solution:
Why does the storage subsystem fail to create logical disk with maximum size?
Symptoms:
Solution:
142 Troubleshooting
This can be caused by several factors:
Another application is running on the same or different system and connects to the
subsystem. Some storage subsystems only allow a single application to connect and
perform management functions on them.
The subsystems do not have an FC link to the Simple SAN Connection Manager
system. Simple SAN Connection Manager requires a direct FC link to discover and
manage the subsystem.
The subsystem's hardware provider has not been installed or registered on the
Simple SAN Connection Manager system.
Ensure that your subsystems have a direct FC link and that the subsystem's hardware is
registered on Simple SAN Connection Manager.
When I try to start Simple SAN Connection Manager, it does not open and I get an
error message. This happens when multiple copies of Simple SAN Connection
Manager are trying to be used within the SAN at the same time. On launching Simple
SAN Connection Manager, a message box saying:
The application cannot run. No storage subsystem was
detected.
Close all instances of Simple SAN Connection Manager running on other machines
connected to the SAN, and then re-launch Simple SAN Connection Manager.
When creating a logical disk with the maximum size allowed, some storage subsystems
fail the request with one of the following error messages:
Not enough space for the new logical disk.
Cannot complete the logical disk creation request.
This could be because the subsystems do not have enough space for the new logical
disk's size. The subsystems might need space for the new logical disk overhead or
space is not available because of bad sectors on the drives.
When this problem occurs, reduce the logical disk size and re-initiate the logical disk
creation request.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sn6000Storageworks simple san connection manager 3.20

Table of Contents