Download Print this page

Telephone Operation - AT&T 7620 User Manual

Cordless answering system telephone

Advertisement

In order to "hang up" the handset when the base is wall mounted, you'll need to remove the switch
hook, reverse it, and replace it in the base.
5.
Connect the telephone line cord.
Plug one end of the telephone line cord into the jack on the top side of the base. Plug the other end of
the line cord into a modular jack. Make sure the plug snaps firmly in place.
6.
Mount the base on the wall.
Hold the base so the mounting sleeves on the wall fit into the holes on the bottom of the base. Slide the
base down onto the mounting sleeves until it locks into place.
7.
Follow Steps 7-9 in TABLE INSTALLATION.
Setting the Clock
The clock feature will record the day and time of each message received.
NOTE: If the clock is not set, the time/day of each message will not be present.
To set the clock (open cassette door)
1.
Press CHANGE, then CLOCK. You hear a day of the week.
2.
Press REPEAT or FORWARD until you hear the correct day.
3.
Press CLOCK to hear the hour.
4.
Press REPEAT or FORWARD until you hear the correct hour. Make sure the hour is correct for AM
or PM.
5.
Press CLOCK to hear the minute.
6.
Press REPEAT or FORWARD until you hear the correct minute.
7.
Press CLOCK. You will hear the day and time setting.
To review the clock
Press CLOCK. You will hear the day and time setting.
NOTE: If AC power fails you will need to reset the clock.

Telephone Operation

Making a Call
1.
Press PHONE and wait for the PHONE light to go on.
2.
When you hear a dial tone, dial the number.
NOTE: You might experience a slight delay before you hear a dial tone, as the AutoSelect ® feature
searches for a clear channel.
Answering a Call
If the handset is in the base, lift the handset. The PHONE light goes on, and the call is connected.
If the handset is away from the base, press PHONE. The PHONE light goes on, and the call is
connected.
Ending a Call
If you are near the base, place the handset in the base.
If you are away from the base, press OFF.
Redial
The last number dialed on this phone is stored in redial memory until you dial another number.

Advertisement

loading