Connecting A Vcr - Sony VPL-EX130 Operating Instructions Manual

To connect a computer
Rear side
to monitor output
to audio input
1 HD D-sub 15-pin cable (supplied)
2 Stereo audio connecting cable (not supplied)
(Use a no-resistance cable.)
Notes
• For stereo audio connection, connect the
stereo audio connecting cable to the INPUT
A/B AUDIO connector.
• The projector accepts VGA, SVGA, XGA,
SXGA, SXGA+, WXGA signals. However,
we recommend that you set the output mode
of your computer to XGA mode for the
external monitor.
• If you set your computer, such as a notebook
computer, to output the signal to both your
computer's display and the external monitor,
the picture of the external monitor may not
appear properly. Set your computer to output
the signal to only the external monitor.
18
Connecting the Projector
Computer
For details, refer to the operating
instructions supplied with your computer.
Note
To connect a Macintosh computer equipped
with a video output connector of a type having
two rows of pins, use a commercially available
plug adaptor.

Connecting a VCR

This section describes how to connect the
projector to a VCR.
For more information, refer to the
instruction manuals of the equipment you
are connecting.
To connect to a video or S video
output connector
Rear side
to audio
output (L)
to S
to video
video
output
output
VCR
1 Stereo audio connecting cable (not supplied)
(Use a no-resistance cable.)
to audio
output (R)