D Functional Execution Command Table; Image Command Table; Pc Adjust Control Command Table; Input Control Command Table - Canon LV-7575 Specifications

LV-7575 Expand Serial Command Functional Specifications
5• D Functional Execution Command Table

5.1 Image Command Table

Execute command
CF_BRIGHT_%1 [CR]
CF_CONT_%1 [CR]
CF_COLOR_%1 [CR]
CF_TINT_%1 [CR]
CF_SHARP_%1 [CR]
CF_GAMMA_%1 [CR]
CF_WBAL-R_%1 [CR]
CF_WBAL-G_%1 [CR]
CF_WBAL-B_%1 [CR]
CF_COLTEMP_%1 [CR]
CF_NZRED_%1 [CR]
CF_PROGV_%1 [CR]
CF_IMAGE_%1 [CR]
CF_IMAGEADJ_%1 [CR]
CF_APCTRL_%1 [CR]
CF_COLMNSAV_%1 [CR]
CF_COLMNLD_%1 [CR]

5.2 PC Adjust Control Command Table

Execute command
CF_FSYNC_%1 [CR]
CF_TDOTS_%1 [CR]
CF_CLPPHASE_%1 [CR]
CF_CLPWIDTH_%1 [CR]
CF_H-POS_%1 [CR]
CF_V-POS_%1 [CR]
CF_DDOTS_%1 [CR]
CF_DLINE_%1 [CR]
CF_SETPCADJ_%1 [CR]
CF_ORGMODE_%1 [CR]
CF_PCSTORE_%1 [CR]
CF_PCMODEFREE_%1 [CR]

5.3 Input Control Command Table

Execute command
CF_INPUT_%1 [CR]
CF_SOURCE_%1 [CR]
CF_INPUT1_%1 [CR]
CF_INPUT2_%1 [CR]
CF_INPUT3_%1 [CR]
CF_INPUT4_%1 [CR]
CF_SYSTEM_%1 [CR]
Set value of Brightness
Set value of Contrast
Set value of Color
Set value of Tint
Set value of Sharpness
Set value of Gamma
Set Red value of White Balance
Set Green value of White Balance
Set Blue value of White Balance
Set level of Color Temprature
Set ON/OFF of Noise reduction
Set mode of Progressive scan
Set Image mode
Set Store/Reset of values in Image Adjustment
Set level of Auto Picture Control
Set area to store current values of Color Management
Set area to load values of Color Management
Set value of Fine Sync
Set value of Total Dots
Set value of Clamp Phase
Set value of Clamp Width
Set value of Horizontal Position
Set value of Vertical Position
Set value of Display Dots
Set value of Display Line
Apply values set in PC Adjust menu to screen image
Specify the original signal for PC mode
Store current setting values in PC Adjust menu to
Mode %1
Delete the values registered in Mode %1 and return it to
Free status.
Select Input
Select Source of selected Input
Select Input1 and also set input source to %1
Select Input2 and also set input source to %1
Select Input3 and also set input source to %1
Select Input4 and also set input source to %1
Select System of curretnlty selected Input
Item
Item
Item
11/71