Printing On Both Sides Of The Paper (Duplexing) - Dell V525W Manual

Printing
4
If you want to change the default print settings:
a
Press to access the PictBridge menu.
b
Press the arrow buttons to select the paper source, paper setup, photo size, number of photos per page and
print quality. You can also enhance the quality of graphics. Press
Note: The printer will use the default print settings unless you change the print settings from the camera.
5
See the documentation that came with the camera to begin printing.
Note: If you insert the USB cable of the PictBridge‑enabled camera while the printer is performing another job, then
wait for the job to finish before printing from the camera.

Printing on both sides of the paper (duplexing)

Printing on both sides of the paper (duplexing) automatically
Notes:
• The automatic duplex unit supports A4‑ and letter‑size paper. It also supports plain, premium plain, ColorLok
certified plain, heavy plain, and letterhead paper types.
•
Do not remove the page until printing is finished.
Warning—Potential Damage: Do not touch the duplex latch or latches while actively printing.
For Windows users
1
With a document open, click File > Print.
2
Click Properties, Preferences, Options, or Setup.
3
Navigate to:
Layout tab > Print on Both Sides (Duplex) area > Print on both sides
• Click Long edge for print jobs with pages that are bound along the long edge of the page.
•
Click Short edge for print jobs with pages that are bound along the short edge of the page.
4
Click the Paper/Finishing tab, and then select a supported paper type.
5
Click OK to close any printer software dialogs.
6
Click OK or Print.
To return to single-sided printing, repeat steps 1 and 2, and then navigate to:
Layout tab > Print on Both Sides (Duplex) area > Print on one side only
For Macintosh users
1
With a document open, choose File > Page Setup.
2
From the Page Setup dialog, set the printer, paper size, and orientation.
3
Click OK.
4
From the menu bar, choose File > Print.
each time you make a selection.
42