KIP C7800 User Manual page 55

6-4. Make sure of the followings prior to an initial cut.
- The Roll Deck drawer which you want an initial cut is fully opened
- The upper Roll Deck drawer are firmly closed
NOTE
For Roll Deck 2 and 3, the upper drawer should be closed. If it is open, the leading edge
would have an initial cut improperly by touching its bottom.
6-5. Press the Initial Cut button.
The leading edge automatically proceeds and has a cut off. The portion will be ejected upward.
6-6. Remove the portion. Close the Roll Deck.
Reference
Details of the Initial Cut is described in [2.7 Initial Cut (Straighten the leading edge of roll
media)].
7. This is the end of removing mis-feed media.
3-8 Chapter 3 Troubleshooting