HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server Administrator's Manual page 162

Front Panel Lights, Autoloader
file:///D|/ADMIN_~1/eng/tape/lights_a.htm (9 of 17) [5/3/2000 3:33:43 PM]
Non-MRS
8021
Tape
Clean
Fail:
8009
Check
Cleaning
Tape
2001
Clean Me
1008
Cleaning
Config:
xxy
2006
Close Door
Drive
8002
Comms
Error
A WRITE, WRITE FILEMARK
or ERASE command has been
attempted on a non-Media
Recognition System cartridge.
E F
Action: Remove the cartridge and
replace with a Media Recognition
System cartridge. See
Cartridges.
Cleaning failed, possibly due to an
expired cleaning tape.
E F
Action: Use a new cleaning
cartridge.
A high error rate has been detected
reading or writing.
Action: Insert a cleaning cartridge
E F
to clean the tape heads, ensuring
that the tape in the cleaning
cartridge has not been used up. See
Cleaning the Tape
A cleaning cartridge has been
S
loaded into the drive mechanism.
This message is displayed for two
seconds during the power-up
sequence following the SCSI ID.
"xx" is the hex value of the
I configuration switch setting on the
underside of the autoloader. "y" is
the autoloader option switch value
set on the rear panel of the
autoloader.
The front panel door is open. Any
autoloader motion will be delayed.
Action: This is probably caused by
E F
a magazine that is partly inserted
through the door. Push the
magazine fully into the drive or
remove it.
The drive has stopped
communicating with the changer
E O
mechanism.
Action:
Choosing
Heads.
Call for service.