Ospfv3 (Ei Mode Only) - D-Link DGS-3620-28PC-SI Product Manual

xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Transit Area ID
Virtual Neighbor
Router ID
Click the Find button to find the specified entry.
Click the View All button to view all the entries.

OSPFv3 (EI Mode Only)

OSPFv3 Global Settings
This window is used to configure the OSPFv3 Global settings for the Switch.
To view the following window, click L3 Features > OSPF > OSPFv3 > OSPFv3 Global Settings, as shown below:
The fields that can be configured or displayed are described below:
Parameter
OSPFv3 State
OSPFv3 Router ID
Current Router ID
Click the Apply button to accept the changes made.
OSPFv3 Area Settings
This window is used to configure the OSPFv3 Area settings for the Switch.
To view the following window, click L3 Features > OSPF > OSPFv3 > OSPFv3 Area Settings, as shown below:
Figure 5-46 OSPF Virtual Neighbor Table window
Description
A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies
the OSPF area in the OSPF domain.
The OSPF router ID for the remote area. This is a 32-bit number in the form of an IP
address (xxx.xxx.xxx.xxx) that uniquely identifies the remote area's Area Border Router.
Figure 5-47 OSPFv3 Global Settings window
Description
Click the radio buttons to enable or disable the OSPFv3 global state.
Enter a 32-bit number in the form of an IPv4 address that uniquely identifies the router
in the OSPFv3 domain. Setting it to be 0.0.0.0 means auto-selected. The Switch will
select the largest IPv4 address among the IP interfaces to be the router ID.
Display the OSPF Route ID currently in use by the Switch. This Route ID is displayed
as a convenience to the user when changing the Switch's OSPF Route ID.
190